• Figure 1. Assembled box before installing the bracing.
  • Figure 2. Box with all but two pieces of bracing installed.
  • Figure 3. Applying stain to a box.
  • Figure 4. Removing excess glue after screwing in the bracing.
  • Figure 5. Soldering wires to the input terminal cup.
  • Figure 6. More staining.
  • Figure 7. Crossover network assembly.
  • Figure 8. A finished crossover network.
  • Figure 9. Closeup of a crossover network.
  • Figure 10. Measuring a fiberglass piece.
  • Figure 11. Soldering the speaker wires to the crossover network.
  • Figure 12. Installing the fiberglass lining.
  • Figure 13. More soldering speaker wires to the crosssover network.
  • Figure 14. Box before screwing the crossover network to the bottom.
  • Figure 15. Soldering the input wires to the crossover network.
  • Figure 16. An assembled box before putting fiberglass on the back panel and over the crossover network.
  • Figure 17. A box with the back panel ready to be screwed on.
  • Figure 18. Box with back panel screwed on (I would have used more screws.)
  • Figure 19. Front view of an assembled box.
  • Figure 20. The finished speakers.